Ex parte DAROVIC - Page 12




          Appeal No. 1994-4016                                                        
          Application No. 07/793,824                                                  


               defined by the horizontal table 20.  The bars 65 and                   
               70 are securely attached to bar supports 75 and 80,                    
               and bar supports 85 and another (not shown), which                     
               are securely attached to vertical support 15.                          
          We observe that the specification defines "a cutter rotating                
          means" as follows (page 8, lines 12-21, and page 15, lines 8-               
          15):                                                                        
                    Also attached to plate 55 is a cutter rotation                    
               assembly 125, the cutter rotation assembly 125                         
               protruding through a vertical support cavity 120 in                    
               the vertical support 15.  The vertical support                         
               cavity 120 is sized to accommodate the cutter                          
               rotation assembly 125 through the complete movement                    
               of the sliding support 60 from the point where the                     
               plate 55 rests at the bottom point 112 of the                          
               parallel bars 65 and 70 (not shown) to the point                       
               where the plate 55 is moved to the top of the                          
               parallel bars 65 and 70 at top point 130.  The                         
               cutter rotation assembly 125 has a shaft 135,                          
               extending through a hole 140 in the plate 55.                          
                    . . . .                                                           
                    Another alternate embodiment shown in Figure 17                   
               is constructed substantially as the preferred                          
               embodiment, except that the cutter rotation assembly                   
               425 is not attached to plate 55 (shown in Figure 1).                   
               Instead, as shown in Figure 17, bar 405 is attached                    
               to a stationary support ( not shown) which allows                      
               tracing assembly 410 to move up and down through an                    
               arch which allows the cutter 445 to cut the front                      
               face of the workpiece and then the top surface of                      
               the workpiece as the workpiece is moved under the                      
               cutter 445.                                                            
          We observe that the specification defines "means for tracing"               

                                         12                                           





Page:  Previous  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  Next 

Last modified: November 3, 2007