Ex parte D'AMORE et al. - Page 6




          Appeal No. 2000-0003                                       Page 6           
          Application No. 08/618,814                                                  


               diameter; and       effecting at least one expanding                   
               operation on a part of said peripheral wall situated                   
               above said region of said given diameter for producing                 
               said succession of regions of different diameters of said              
               peripheral wall.                                                       


               Dolveck discloses a process for making a hollow metallic               
          article from a tubular blank closed at one end.  Dolveck                    
          provides that the process deforms the entire periphery of the               
          wall of the blank over its entire length from one end to the                
          opposite end.  Dolveck teaches (column 1, lines 10-12; column               
          5, lines 36-41) that the hollow metallic article obtained                   
          according to his process can be used not only as an aerosol                 
          container but also as a soda water bottle or a flower vase.                 


               As shown in Figure 1 of Dolveck, a basic metal container               
          1 having a flat base and open at the opposite end 2 from the                
          base, is made by a known drawing and pressing operation.  This              
          forms the basic tubular blank on which all the remaining                    
          operations are to be performed.  The end 2 is trimmed by a                  
          metal cutter or                                                             
          grinding wheel, to any desired length to produce a container 1              
          as shown in Figure 2.  Thereafter, a base 3 of container 1 is               







Page:  Previous  1  2  3  4  5  6  7  8  9  10  11  12  13  Next 

Last modified: November 3, 2007