§291C-202 Moped equipment requirements and inspection. (a) Every moped offered for sale for use upon, sold for use upon, or used upon the roadways and highways shall be equipped with:
(1) A motor having a maximum power output capability, measured at the motor output shaft, in accordance with the Society of Automotive Engineers standards, of two horsepower (one thousand four hundred ninety-two watts) or less and, if it is a combustion engine, a maximum piston or rotor displacement of 3.05 cubic inches (fifty cubic centimeters) and which will propel the moped, unassisted, on a level surface at a maximum speed no greater than thirty miles per hour; provided that those mopeds, including those modified pursuant to section 291C-206, registered prior to April 23, 1998 shall continue to be subject to the prior thirty-five miles per hour maximum speed limitation; and
(2) A direct or automatic power drive system which requires no clutch or gear shift operation by the moped driver after the drive system is engaged with the power unit.
(b) The director of transportation by rules and regulations, pursuant to chapter 91, shall establish criteria which shall comply with approved federal regulations for the following moped equipment: brake system; fuel system components; exhaust system components; steering system; handlebars; wheel rims; fenders; a guard or protective covering for drive belts, chains and rotating components; seat or saddle; lamps and reflectors; equipment controls; speedometer; retracting stand; horn; and identification markings.
(c) The director of transportation by rules and regulations, pursuant to chapter 91, shall establish criteria and procedures for the annual safety inspection of every moped. Safety inspection criteria shall include the criteria established by the director of transportation under subsection (b). [L 1978, c 175, pt of §15; am L 1979, c 107, §2; am L 1998, c 25, §1]
Revision Note
"April 23, 1998" substituted for "the effective date of this Act".
Section: Previous 291c-195 291c-196 291c-197 291c-198 291c-199 291c-200 291c-201 291c-202 291c-203 291c-204 291c-205 291c-206 291c-207 291c-221 291c-221.5 NextLast modified: October 27, 2016