The following definitions apply in this Part.
(1) Antenna. - Communications equipment that transmits, receives, or transmits and receives electromagnetic radio signals used in the provision of all types of wireless communications services.
(2) Application. - A formal request submitted to the city to construct or modify a wireless support structure or a wireless facility.
(2a) Base station. - A station at a specific site authorized to communicate with mobile stations, generally consisting of radio receivers, antennas, coaxial cables, power supplies, and other associated electronics.
(3) Building permit. - An official administrative authorization issued by the city prior to beginning construction consistent with the provisions of G.S. 160A-417.
(4) Collocation. - The placement or installation of wireless facilities on existing structures, including electrical transmission towers, water towers, buildings, and other structures capable of structurally supporting the attachment of wireless facilities in compliance with applicable codes.
(4a) Eligible facilities request. - A request for modification of an existing wireless tower or base station that involves collocation of new transmission equipment or replacement of transmission equipment but does not include a substantial modification.
(5) Equipment compound. - An area surrounding or near the base of a wireless support structure within which a wireless facility is located.
(5a) Fall zone. - The area in which a wireless support structure may be expected to fall in the event of a structural failure, as measured by engineering standards.
(6) Land development regulation. - Any ordinance enacted pursuant to this Part.
(7) Search ring. - The area within which a wireless support facility or wireless facility must be located in order to meet service objectives of the wireless service provider using the wireless facility or wireless support structure.
(7a) Substantial modification. - The mounting of a proposed wireless facility on a wireless support structure that substantially changes the physical dimensions of the support structure. A mounting is presumed to be a substantial modification if it meets any one or more of the criteria listed below. The burden is on the local government to demonstrate that a mounting that does not meet the listed criteria constitutes a substantial change to the physical dimensions of the wireless support structure.
a. Increasing the existing vertical height of the structure by the greater of (i) more than ten percent (10%) or (ii) the height of one additional antenna array with separation from the nearest existing antenna not to exceed 20 feet.
b. Except where necessary to shelter the antenna from inclement weather or to connect the antenna to the tower via cable, adding an appurtenance to the body of a wireless support structure that protrudes horizontally from the edge of the wireless support structure the greater of (i) more than 20 feet or (ii) more than the width of the wireless support structure at the level of the appurtenance.
c. Increasing the square footage of the existing equipment compound by more than 2,500 square feet.
(8) Utility pole. - A structure that is designed for and used to carry lines, cables, or wires for telephone, cable television, or electricity, or to provide lighting.
(8a) Water tower. - A water storage tank, a standpipe, or an elevated tank situated on a support structure originally constructed for use as a reservoir or facility to store or deliver water.
(9) Wireless facility. - The set of equipment and network components, exclusive of the underlying wireless support structure or tower, including antennas, transmitters, receivers, base stations, power supplies, cabling, and associated equipment necessary to provide wireless data and wireless telecommunications services to a discrete geographic area.
(10) Wireless support structure. - A new or existing structure, such as a monopole, lattice tower, or guyed tower that is designed to support or capable of supporting wireless facilities. A utility pole is not a wireless support structure. (2007-526, s. 1; 2013-185, s. 1.)
Sections: Previous 160A-400.27 160A-400.28 160A-400.29 160A-400.30 160A-400.31 160A-400.32 160A-400.50 160A-400.51 160A-400.51A 160A-400.52 160A-400.53 160A-401 160A-402 160A-403 160A-404 Next
Last modified: March 23, 2014