(a)
(b) 2-
(A) establish standards for the devices based on performance;
(B) prohibit a railroad carrier, on or after the date that is one year after the regulations are prescribed, from acquiring any end-of-train device for use on trains that is not a 2-way device meeting the standards established under clause (A) of this paragraph;
(C) require that the trains be equipped with 2-way end-of-train devices meeting those standards not later than 4 years after the regulations are prescribed; and
(D) provide that any 2-way end-of-train device acquired for use on trains before the regulations are prescribed shall be deemed to meet the standards.
(2) The Secretary may consider petitions to amend the regulations prescribed under paragraph (1) of this subsection to allow the use of alternative technologies that meet the same basic performance requirements established by the regulations.
(3) In developing the regulations required by paragraph (1) of this subsection, the Secretary shall consider information presented under subsection (a) of this section.
(c)
(1) trains that have manned cabooses;
(2) passenger trains with emergency brakes;
(3) trains that operate only on track that is not part of the general railroad system;
(4) trains that do not exceed 30 miles an hour and do not operate on heavy grades, except for any categories of trains specifically designated by the Secretary; and
(5) trains that operate in a push mode.
(Pub. L. 103–272, §1(e), July 5, 1994, 108 Stat. 878.)
Revised Section | Source (U.S. Code) | Source (Statutes at Large) |
---|---|---|
20141(a) | 45:431(r)(1), (2). | Oct. 16, 1970, Pub. L. 91–458, 84 Stat. 971, §202(r); added Sept. 3, 1992, Pub. L. 102–365, §7, 106 Stat. 976. |
20141(b) | 45:431(r)(3). | |
20141(c) | 45:431(r)(4). |
Sections: Previous 20134 20135 20136 20137 20138 20139 20140 20141 20142 20143 20144 20145 20146 20147 20148 Next
Last modified: October 26, 2015