Appeal No. 96-1701 Application 08/190,211 Appealed claim 1 is representative and is reproduced below: 1. A method of forming a Josephson junction device comprising the steps of: forming a non-superconducting oxide film of Bi-Sr- Cu-O compound by sequentially depositing at least Bi, Sr and Cu on a magnesia substrate in a pattern; and forming a superconducting oxide film of Bi-Sr- Ca-Cu-O compound by sequentially depositing at least Bi, Sr, Ca and Cu over the exposed part of said magnesia substrate and said non-superconducting oxide film to form a tilt-boundary junction between said superconducting oxide film on said magnesia substrate and said superconducting oxide film on said non- superconducting oxide film. The references of record relied upon by the examiner are: Char et al. (Char) 5,157,466 Oct. 20, 1992 Vasquez et al. (Vasquez), Appl. Phys. Lett., ?Nonaqueous chemical depth profiling of Yba Cu O ?, Vol. 54, No. 11, pages 1060-1062 2 3 7-x (1989). Mizuno et al. (Mizuno), Appl. Phys. Lett., ?Fabrication of thin- film-type Josephson junctions using a Bi-Sr-Ca-Cu-O/Bi-Sr-Cu-O/ Bi-Sr-Ca-Cu-O structure?, Vol. 56, No. 11, pages 1469-1471 (1990). Tsukamoto et al. (Tsukamoto), Japanese Journal of Applied Physics, ?Low-Temperature Annealing Effect on Bi-Sr-Ca-Cu-O Thin Films Prepared by Layer-by-Layer Deposition?, Vol. 30, No. 5A, pages L830-L833 (1991). Tsukada et al. (Tsukada), Supercond. Sci. Technol., ?In-situ of Bi-Sr-Ca-Cu-O films by shutter-controlled molecular beam epitaxy?, 4, pages 118-120 (1991). 2Page: Previous 1 2 3 4 5 6 NextLast modified: November 3, 2007