Ex Parte KIKUCHI et al - Page 5



          Appeal No. 2003-2020                                                        
          Application No. 08/944,208                                                  

          resin as a second component with lower heat-deforming                       
          temperature.  Therefore, Kato discloses a disk cartridge made of            
          at least two types of thermoplastic resins with different heat-             
          deforming temperatures.                                                     
               Kato further discloses (column 14, lines 33-35) that an                
          inorganic filler may be added to the polymeralloys described                
          above (which includes the styrol/polycarbonate polymeralloy                 
          relied upon by the examiner).  Kato states (column 16, lines 31-            
          36) that calcium carbonate (one of the fillers used by appellants           
          on page 11 of the specification) is one of the preferred                    
          inorganic fillers.  In addition, Kato explains (column 16, line             
          62-column 17, line 4) that the benefit of using filler, provided            
          the weight percent is within a particular range, is increased               
          rigidity.                                                                   
               As recognized by the examiner (Final Rejection, page 3), the           
          only limitation that Kato fails to teach is the addition of an              
          antistatic polymer.  The examiner applies Yamamoto to remedy this           
          deficiency.  Specifically, Yamamoto's objective is an antistatic            
          material having a high reliability for a container or package for           
          electronic packages (see column 1, lines 56-63).  Yamamoto                  
          teaches (column 2, line 62-column 3, line 17) that for the base             
          polymer, ABS resin or polycarbonate resin, among others, may be             
                                          5                                           




Page:  Previous  1  2  3  4  5  6  7  8  9  10  11  12  Next 

Last modified: November 3, 2007